What Should an Omaha Roofing Contractor Check After High Winds and Hail?

September 16, 2026

A storm rolls through the metro, the wind dies down, and the hail stops. Now you’re staring at your roof and wondering what a roofing contractor would actually look for up there.

Here is the short answer. After high winds and hail, a good roofing contractor checks the shingles on every slope, the flashing and vents, the gutters, and the attic and ceilings inside your home. Then they hand you photos and a written scope of work. If someone glances at one side of the roof and gives you a verdict, that is a glance, not an inspection.

What Does a Roofing Contractor Look for on the Shingles?

Wind and hail hurt shingles in different ways, so a thorough contractor checks for both.

Wind lifts, curls, and tears shingles. It can also crease them. GAF, a major shingle manufacturer, notes that even if a shingle doesn’t blow off, wind stress can crease it enough that it no longer sheds water well. Hail works more like a hammer, bruising the asphalt mat underneath the surface. GAF also points out that some of this damage, hail bruising in particular, is invisible to an untrained eye.

That is why a contractor does more than look. They check ridge caps and roof edges where wind hits hardest, and they often press on shingles to find soft spots you would never see from the yard. They also look for granule loss. Granules protect the asphalt below, so a roof that has been stripped of them ages faster, as the IBHS research on shingle damage explains.

What Can You Safely Check Before the Contractor Arrives?

Stay off the roof. Wet shingles are slick, and walking on them can damage shingles that were fine. Instead, walk the property and look up. Check the yard for pieces of shingle, look at the roof edges with binoculars if you have them, and note any dents in gutters, downspouts, or metal vents. Take photos of what you find, including fallen branches. It takes ten minutes, and it gives your contractor a head start on where to look first.

Why Do Flashing, Vents, and Gutters Matter?

Because water finds the weak points first. Flashing seals the joints around chimneys, vents, and skylights. Wind can bend or loosen it, hail can dent or crack it, and any gap lets water in. Your contractor should check the flashing, the sealant around it, the pipe boots, and the vents to make sure everything is still attached and sealed.

Gutters tell a story too. Dents in gutters and downspouts are a quick read on how hard hail hit your property. Granules collecting in the gutters or at the base of a downspout are another sign the shingles took a beating. A contractor will often start there because it shows them where to look closer.

What Should Get Checked Inside Your House?

A real roof inspection does not stop at the shingles. Your contractor should check the attic for damp insulation, water stains on the underside of the decking, or a musty smell. You can do part of this yourself by looking at your ceilings and walls for new brown stains, bubbling paint, or damp spots.

Timing matters here. Wind-driven rain can slip in through small openings around flashing, and the leak may not show up until days later. If you already see a stain, our guide on what to do immediately after a roof leak in Omaha walks through the first steps.

What Should You Walk Away With After the Inspection?

You should leave with evidence, not just an opinion. Ask for photos of every slope and every problem area, plus a written summary of what was found and what it recommends. The Nebraska Department of Insurance encourages homeowners to document hail damage with photos and video before repairs begin, and a good inspection report helps you do that.

The report should also give you a clear call on repair versus replacement. If you want to understand your options, our roofing services page covers the materials and work we handle.

How Do You Choose a Roofing Contractor Omaha Homeowners Can Trust?

Start with the paperwork. Nebraska does not issue a statewide roofing license, but contractors doing business in the state must register with the Nebraska Department of Labor, and Omaha adds its own local contractor licensing on top. Ask any roofing contractor Omaha homeowners are considering to show you both, along with proof of insurance.

Then do your homework, because nobody else will do it for you. The Nebraska Department of Insurance does not regulate contractors’ conduct, so references and written estimates matter. The Department also advises getting your insurer’s approval before permitting repairs. If you sign a contract and later learn your insurer won’t cover all or part of the claim, you have three days to cancel in writing.

Be careful with any paperwork that hands over control of your claim. A post-loss assignment gives a contractor the rights and duties of the claim, and it can leave you paying the difference if the contractor’s price is higher than the insurance payout. Read before you sign, and ask what each page does.

What Is the Takeaway?

Wind and hail don’t always leave obvious evidence, which is exactly why the checklist matters. A roofing contractor worth hiring checks the whole roof, shows you the proof, and explains your options in plain language. You shouldn’t have to take anyone’s word for what is on your roof. Ask to see it.

Want a second set of eyes after the storm? ReThink Construction & Claims is a licensed Class A contractor with more than eight years of experience serving Omaha, Lincoln, Council Bluffs, and the surrounding areas. We offer free inspections and will walk you through exactly what we find. Call us at 402-575-7584 or email info@rethinkomaha.com to schedule yours.

Address

17406 Storage Rd Suite D
Omaha, NE 68136

Phone

402-575-7584